Di Posting Oleh : Simple Learning
Kategori : MPLS
Prerequisites: CCNP level skills.
Note!
This lab layout is based on the new physical topology presented here. This lab assumes that you have successfully configured ALL previous MPLS labs.
IMPORTANT!
As per recommendation ALL loopback addresses on P and PE routers will use /32 network mask!
IMPORTANT!
As per recommendation ALL loopback addresses on P and PE routers will use /32 network mask!
Topology
Pic. 1 - MPLS Topology.
Task 1
Configure two additional loopback interfaces in SW1 and advertise all of them using EIGRP. The new loopback addresses should be as follows:
- Loobpack1 = 192.168.7.1/28
- Loopback2 = 192.168.7.17/28
Task 2
Configure two additional loopback interfaces in SW4 and advertise all of them using EIGRP. The new loopback addresses should be as follows:
- Loobpack1 = 192.168.10.1/28
- Loopback2 = 192.168.10.17/28
Task 3
Configure routers such that SW1 and SW4 subnets are reachable. Use peer-to-peer VPN to accomplish this.
Solution
0 Response to "Lab 174 - MPLS VPN using EIGRP"
Post a Comment