Di Posting Oleh : Simple Learning
Kategori : Multicast
Prerequisites: CCNP level skills.
Note!
All routers are running EIGRP protocol as well as multicast routing.
Topology
Pic. 1 - Topology Diagram.
Icons designed by: Andrzej Szoblik - http://www.newo.pl
Task 1
Multicast server is located on 10.1.234.0/24 subnet. It sends the multicast stream using 224.4.4.4 address. Enable multicast on all routers so that. R1 should be the Rendezvous Point (RP) in this network.
Solution
Task 1
Multicast server is located on 10.1.234.0/24 subnet. It sends the multicast stream using 224.4.4.4 address. Enable multicast on all routers so that R1 should be the Rendezvous Point (RP) in this network.
All routers:
!
ip pim rp-address 172.16.101.1
!
All routers similar to R1 below (all interfaces are sparse-mode)!
R1 Configuration:
!
interface Ethernet0/0
ip address 10.1.51.1 255.255.255.0
ip pim sparse-mode
!
ip address 10.1.51.1 255.255.255.0
ip pim sparse-mode
!
interface Serial1/0
ip address 10.1.123.1 255.255.255.0
ip pim sparse-mode
encapsulation frame-relay
no ip split-horizon eigrp 100
serial restart-delay 0
frame-relay map ip 10.1.123.3 103 broadcast
frame-relay map ip 10.1.123.2 102 broadcast
no frame-relay inverse-arp
ip address 10.1.123.1 255.255.255.0
ip pim sparse-mode
encapsulation frame-relay
no ip split-horizon eigrp 100
serial restart-delay 0
frame-relay map ip 10.1.123.3 103 broadcast
frame-relay map ip 10.1.123.2 102 broadcast
no frame-relay inverse-arp
!
interface Serial1/1
ip address 10.1.15.1 255.255.255.0
ip pim sparse-mode
serial restart-delay 0
ip address 10.1.15.1 255.255.255.0
ip pim sparse-mode
serial restart-delay 0
!
Verification (here just R1, but done on all routers):
Pic. 2 - R1's Multicast-enabled Interfaces.
Pic. 3 - R's Multicast Neighbors.
Pic. 3 - Routers Recognize RP (here: just R4).
R6 Configuration:
!
interface Ethernet0/0
ip address 10.1.56.6 255.255.255.0
ip pim sparse-mode
ip igmp join-group 224.4.4.4
ip address 10.1.56.6 255.255.255.0
ip pim sparse-mode
ip igmp join-group 224.4.4.4
!
R6 should register the group with RP (172.16.101.1). R5 receives the join 244.4.4.4 message and registers (*,G) entry (multicast) client. Then, DR registers this with R1 (RP).
Pic. 5 - R5's Multicast Routing Table Entry for 224.4.4.4.
Pic. 6 - RP Registers 224.4.4.4 Client.
Pic. 7 - Ping Test.
0 Response to "Lab 144 - PIM Sparse-Mode"
Post a Comment