Di Posting Oleh : Simple Learning
Kategori : IPv6
Prerequisites: CCNP level skills.
Topology
Notice!
IPv6 addresses have changed. Follow the below topology diagram and tasks to accomplish the goals.
Pic1. IPv6 Topology Diagram.
Task 1
Enable EIGRPv6 Autonomous System 1 between R1, R5, and SW2. Use addresses presented in the topology diagram. Host portion should follow our previous labs (here: R1=1, R5=5, SW2=8).
Task 2
Allow R5 and SW2 learn all IPv6 prefixes enabled in the previous labs. Configure R1 as a default gateway for all unknown addresses. Do not use summarization to accomplish the goal. You are allowed to use a static route in R1's configuration.
Solution
Task 1
Enable EIGRPv6 Autonomous System 1 between R1, R5, and SW2. Use addresses presented in the topology diagram. Host portion should follow our previous labs (here: R1=1, R5=5, SW2=8).
R1 Config:
!interface FastEthernet0/1
ip address 172.16.215.1 255.255.255.0
speed 100
full-duplex
ipv6 address FC00:1:1:D7::1/64
ipv6 eigrp 1
!
R5 Config:
!ipv6 unicast-routing
!
ipv6 router eigrp 1
no shutdown
!
interface FastEthernet0/1
ip address 172.16.215.5 255.255.255.0
speed 100
full-duplex
ipv6 address FC00:1:1:D7::5/64
ipv6 eigrp 1
!
SW2 Config
!ipv6 unicast-routing
!
ipv6 router eigrp 1
no shutdown
!
interface Vlan215
ip address 172.16.215.8 255.255.255.0
ipv6 address FC00:1:1:D7::8/64
ipv6 eigrp 1
!
Task 2
Allow R5 and SW2 learn all IPv6 prefixes enabled in the previous labs. Configure R1 as a default gateway for all unknown addresses. Do not use summarization to accomplish the goal. You are allowed to use a static route in R1's configuration.
R1 Config:
!ipv6 route ::/0 null0
!
ipv6 router eigrp 1
no shutdown
redistribute static
!
Verification:
Pic. 2 - Default Route in R5.
0 Response to "Lab 198 - EIGRPv6 Default Route 2"
Post a Comment