Di Posting Oleh : Simple Learning
Kategori : Core Technologies RIP Routing
Prerequisites: CCNP level skills.
Topology
Task 1
Using extended ACL configure RIP filtering so that R3 prefers R1 towards 172.16.104.0/24 and R2 should be the gateway towards 172.16.144.0/24.
Pic. 2 - R3's Current Routing Table.
Lab Solution
Task 1
Using extended ACL configure RIP filtering so that R3 prefers R1 towards 172.16.104.0/24 and R2 should be the gateway towards 172.16.144.0/24.
R3 Configuration:
!
access-list 101 deny ip host 10.1.13.1 172.16.144.0 0.0.0.255
access-list 101 permit ip any any
access-list 102 deny ip host 10.1.23.2 172.16.104.0 0.0.0.255
access-list 102 permit ip any any
!
access-list 101 permit ip any any
access-list 102 deny ip host 10.1.23.2 172.16.104.0 0.0.0.255
access-list 102 permit ip any any
!
router rip
version 2
passive-interface Loopback0
network 10.0.0.0
network 172.16.0.0
distribute-list 101 in Serial0/1
distribute-list 102 in Serial0/2
no auto-summary
version 2
passive-interface Loopback0
network 10.0.0.0
network 172.16.0.0
distribute-list 101 in Serial0/1
distribute-list 102 in Serial0/2
no auto-summary
!
Notice!
Source IP address in an extended ACL matches on the IP address of the advertising router if used with the 'distribute-list'.
Notice!
The 'distribute-list' will not take named ACLs as the arguement (as of the time of writing this post).
Notice!
For the changes to take effect quicker use 'clear ip route *'.
Verification:
Pic. 3 - R3's Routing Table.
0 Response to "Lab 69 - RIPv2 Filtering with Extended ACL"
Post a Comment