Di Posting Oleh : Simple Learning
Kategori : Core Technologies RIP Routing
Prerequisites: CCNP level skills.
Topology
Task 1
Change encapsulation on Serial0/1 interfaces between R1 and R3 to PPP. Configure R1, so that it receives the IP address: 10.1.13.1 from R3 using IPCP.
Task 2
Configure R1 so it installs RIP updates sent by R3.
Lab Solution
Task 1
Change encapsulation on Serial0/1 interfaces between R1 and R3 to PPP. Configure R1, so that it receives the IP address 10.1.13.1 from R3 using IPCP.
R1 Configuration:
!
interface Serial0/1
ip address negotiated
encapsulation ppp
serial restart-delay 0
ip address negotiated
encapsulation ppp
serial restart-delay 0
!
R3 Configuration:
!
interface Serial0/1
ip address 10.1.13.3 255.255.255.0
encapsulation ppp
peer default ip address 10.1.13.1
serial restart-delay 0
ip address 10.1.13.3 255.255.255.0
encapsulation ppp
peer default ip address 10.1.13.1
serial restart-delay 0
!
Note!
For this IP address to be assigned, the LCP negotiation must take place (shut, no shut on s0/1 interface).
Verification:
Pic. 2 - R1's Address Assigned via IPCP.
Pic. 3 - R3's Connected Networks.
Pic. 4 - R1's Connected Networks.
R1 installs two host routes (/32) in its routing table. R3 installs a host route but has the /24 subnet entry as well. The result is that R1 and R3 are not on the common subnet.
Pic. 5 - RIP Table on R1.
Pic. 6 - RIP Updates on R1.
Task 2
Configure R1 so it installs RIP updates sent by R3.
R1 Configuration:
!
router rip
version 2
no validate-update-source
passive-interface Loopback0
network 10.0.0.0
network 172.16.0.0
no auto-summary
version 2
no validate-update-source
passive-interface Loopback0
network 10.0.0.0
network 172.16.0.0
no auto-summary
!
Verification:
Pic. 7 - R1's Routing Table.
0 Response to "Lab 78 - RIPv2 Source Update Validation"
Post a Comment